Skip to content
NiagaraDoor & Opener Co.
Open 24/7(289) 271-0174Open 24/7
Person in a jacket facing a closed white sectional door, with coiled springs and steel tubes on a wooden bench. — Extension Spring Replacement, Weller Park
Gloved hand holding a white garage-door roller beside its track, with two loose rollers and a red tool on a tray. — Garage Door Roller Replacement, Weller Park

Springs · Weller Park

Extension Spring Replacement in Weller Park

The opener groans on the way up and the door slams the last foot on the way down, hard enough to rattle the windows.

Call (289) 271-0174

In plain words

Choosing the right spring is a matter of weight, not colour. Extension springs are rated for the weight they are meant to lift, and the correct pair for your door is found by weighing the door itself with the opener released, then checking that figure against the wire size, coil diameter and length of the old springs. Paint colour on the end coil is only a hint; older springs fade, get overpainted or were never quite right to begin with. A pair matched to the measured weight gives a door that holds at half height and lifts with one hand, and an opener that works lightly.

Sound familiar?

The opener groans on the way up and the door slams the last foot on the way down, hard enough to rattle the windows. The motor is the same one it always was; something in the springs has stopped doing its share.

How the visit goes

Extension Spring Replacement

How the visit goes

Garage door opener motor with a chain, a metal rail and a red pull handle lying on a worn workbench. — Weller Park
Technician in a mesh cap driving a screw with a cordless drill into a roller bracket beside a curved metal track. — Weller Park
  1. The rest of the door, and why the spring went

    A spring rarely fails on its own, so the first look ends with the door it was lifting. The technician checks the rollers for cracked wheels and bent stems, the hinges for splits, the track for a bend or a bracket pulled off the jamb, and the bottom section for a dent that catches. The opener's force setting is noted, since an opener turned up to compensate for tired springs will overpower the new ones. And the history matters: a door recently fitted with insulation panels or windows weighs more than the springs were chosen for, and a door that has been closed onto snow or a bin has had its cables jolted.

  2. Running the lift cables

    Each lift cable starts at the bottom bracket, where its loop goes over the pin or is secured with a clevis pin. From there it runs up the vertical track, over the fixed pulley at the front of the horizontal track, back along the track to the pulley on the end of the spring, around it, and forward again to the S-hook or adjusting clip at the front hanger. The technician keeps the cable seated in each pulley groove and makes sure it passes on the correct side of the containment cable and the track. Cables are renewed if the old ones showed any fraying or rust, and always as a pair of the same length.

  3. A door that lifts as it was designed to

    The difference is felt the first time you pull the release cord and lift the door yourself. It rises with one hand, pauses where you leave it, and comes down at the speed you lower it rather than dropping the last stretch. Under power, the opener runs without the strain in its note that had crept in as the old springs tired, and the door reaches the floor evenly along the seal. Both springs now stretch to the same length as the door closes, both pulleys turn without a squeal, and the cables lie in their grooves. A door in this condition puts little wear on the opener, which is good news for the motor.

Extension Spring Replacement

In the van

  • Bottom brackets and clevis pins

  • Garage-door spray lubricant

  • Track clamps or locking pliers

  • Rear spring hangers and angle iron

  • Extension springs, matched pair

Four long coiled garage-door springs on a concrete floor, three black with metal end cones and one rusty spring broken in two. — Weller Park

Extension Spring Replacement

What affects the quote

  1. Time of the call

    An evening, weekend or holiday visit costs the same amount as a weekday daytime appointment for an extension-spring replacement. The technician confirms the exact figure once the springs, cables and door weight have been checked on site.

  2. Working room around the springs

    Shelving, a stored canoe or a car parked under the tracks slows the work along the horizontal run. Clearing the sides of the garage beforehand keeps the time on the quote short.

  3. Hangers and anchor points

    A rear hanger that has loosened, a front bracket bent by a jumped cable, or framing that needs a new anchor point adds fasteners, angle iron and a little time.

What to have ready

  • Do you know how old the springs are or when they were last changed?
  • Does the door drop the last bit, or drift up on its own?
  • Does one corner of the door hang lower than the other?
Call (289) 271-0174

Extension Spring Replacement: questions

Questions
Why does the door slam down the last bit?

A door that drops the final stretch is telling you the springs are no longer holding it. As an extension spring loses its temper it gives less pull near the bottom of travel, where the door needs the most support, so the door falls that last foot. Fresh springs matched to the door's weight bring the door down under control and take that shock off the bottom section and the opener.

What does the paint colour on the end of the spring mean?

Manufacturers dab a colour on the end coil to indicate the spring's weight rating, which is a handy starting point. It is not the final word: a faded or repainted end coil tells you little, and the pair on an older door may have been a near match rather than the right one. The technician treats the colour as a hint and confirms the rating from the door's measured weight and the spring's own dimensions.

How do you know which springs my door needs?

By weight. Extension springs are rated for the weight they lift, so the technician releases the opener and weighs the door on a scale, then matches that figure and the door's height to a spring rating and stretch length. The old springs are measured as a check on wire size, coil diameter and length. Where the two disagree, the scale decides, since doors gain weight from added insulation or panels.

Related services

Extension Spring Replacement near you

Call(289) 271-0174

Request a visit

Or call (289) 271-0174 · open 24/7